ROUTINE INSPECTION
Notes: - This is the first routine inspection after plan check and a change of ownership.
4 reported violations
- K35: Equipment, utensils: Approved, in good repair, adequate capacity
1. Facility has two non-ANSI microwaves and a non-ANSI toaster oven. [CA] New and/or replacement food equipment shall be certified or classified for sanitation by an American National Standards Institute (ANSI) accredited certification program (e.g. NSF, UL EPH, UL Sanitation, CSA Sanitation, or ETL Sanitation) 2. The display cooler is not maintaining PHFs at 41F or below. [CA] Refrigeration must be capable of maintaining PHFs at 41°F or below. Refrain from storing PHFs until either repaired, serviced, or replaced.
- K36: Equipment, utensils, linens: Proper storage and use
Rice serving utensils were found in containers of water measured at 86F. [CA] Utensils shall be stored in the following manner: 1) in the food with their handles above the top of the food and the container, 2) in running water, 3) in a container of water at 135°F or above, 4) at room temperature if washed within 4 hours of initial use.
- K08: Time as a public health control; procedures & records
Facility is using TPHC without written procedures. Observed a log of foods kept using time as a control. [CA] Provide written procedures and time marking for PHFs utilizing time as a public health control (TPHC). [COS] TPHC written guidelines were provided onsite and approved.
- K07: Proper hot and cold holding temperaturesCritical
Potentially Hazardous Foods in the display cooler were measured between 44-48F. Ambient air of the unit measured at 44F and the unit was set to the coldest setting. [CA] PHFs shall be held at 41°F or below or at 135°F or above. [COS] Items that had been in the cooler for longer than 4 hours and were out of temperature control were discarded. A few items were cooling down from about 3 hours prior which were moved to working refrigeration units.