FOLLOW-UP INSPECTION
On-site for an operator scheduled follow-up inspection after facility was closed due to sewage backup. During the follow-up inspection, no evidence of sewage backup was observed. All three compartment sinks in facility observed capable of properly draining. Per the PIC, affected areas of the facility have been cleaned/sanitized. Compliance of the following major violations has been verified: K07M: Improper hot and cold holding temperatures: - All potentially hazardous foods measured at 41F or below in multiple refrigeration units. K14M: Food contact surfaces unclean/unsanitized: - Discussed proper wash, rinse, and sanitize procedures for food contact surfaces with the PIC K18M: Noncompliance with ROP (reduce oxygen packaging): - No evidence of in-house vacuum packaging observed. Observed vacuum packaging machine, which has had its power bank removed. Per the PIC, the vacuum packaging machine will be removed from the facility tomorrow. *Note: Observed commercially vacuum packaged pork belly in the three door upright freezer at the back of the kitchen. Invoices provided from SJ Distributors. K21M: Hot water not available: - Water of greater than 100F was available at all three, three compartment sinks. Water measured at 117F maximum at all three sinks. See minor violation above. K22M: Sewage and wastewater improperly disposed: - No evidence of sewage backup observed. All three compartment sinks in facility observed capable of properly draining. Facility may now be reopened and resume normal operation. Continue to work on the violations cited during the last routine inspection conducted.
1 reported violation
- K21: Hot and cold water available
Water measured at a maximum of 117F from the following sinks: - three compartment sink at the front service area - the two three compartment sinks at the back dishwashing area. [CA] Hot water shall be supplied at a minimum temperature of at least 120°F measured from the faucet throughout facility except at handwash sinks.