88
Latest score
100%
Pass rate
1
Inspections
1
Critical violations

Location

Latest inspection

PASSED
Oct 30, 2025ROUTINE INSPECTION289 days ago

Note: The facility sells liquor drinks and beers. No other food products are served in the bar.

Inspection Timeline

Oct 30, 2025Latest
PassedScore: 88/100
ROUTINE INSPECTION
88

Violations Analysis

1
Critical Violations
1 in last 3 inspections
2
Non-Critical
3
Total Violations
Across 1 inspections

Complete inspection history

1 inspections
PassLatest Oct 30, 2025
88/100

ROUTINE INSPECTION

Note: The facility sells liquor drinks and beers. No other food products are served in the bar.

3 reported violations
  • K41: Plumbing approved, installed, in good repair; proper backflow devices

    The drainpipe from the ice machine is immersed inside the floor sink. [CA] To prevent possible contamination from backup of sewage, please provide at least one inch air gap between the floor sink and the drainpipes.

  • K14: Food contact surfaces clean, sanitizedCritical

    The sanitizer concentration on the kitchen's three compartment warewash sink was measured at 0 ppm chlorine. [CA] Whenever sanitizing utensils/equipment is conducted using a three compartment warewash sink, there must be a 100-ppm residual chlorine or 200 ppm quaternary ammonia sanitizer level on the sanitizing compartment. The person in charge refilled one sink of the warewash sink with lukewarm water and added bleach manually to create a 100-ppm chlorine solution to sanitize the utensils (COS). Heavy mold-like buildup was observed inside the ice machine’s internal part. [CA] Clean the internal part of the ice machine immediately.

  • K34: Warewash facilities: installed/maintained; test strips

    There is no approved sanitizer measuring strip to measure the concentration of the chemicals used to sanitize dishes and utensils in the facility. [CA] Provide approved sanitizer measuring strips for the chemicals used in sanitizing utensils. equipment, and food contact surfaces.

Source: Santa Clara County open data. Records are supplied as-is and may take 24–48 hours to reflect a newly published inspection.