ROUTINE INSPECTION
Routine inspection conducted in conjunction with complaint investigation: CO0158452
6 reported violations
- K14: Food contact surfaces clean, sanitized
1) Accumulation of grime observed on bar soda guns and inside nozzles. [CA] Routinely clean and sanitize soda guns and nozzles to prevent buildup. 2) Accumulation of mold-like substance and stains observed on interior of ice machine. [CA] Routinely clean and sanitize ice machine to prevent buildup.
- K39: Thermometers provided, accurate
Multiple refrigeration units are lacking thermometers. [CA] A thermometer +/- 2°F shall be provided and correctly located in each cold holding unit containing potentially hazardous foods. Place thermometer where it is easily visible while checking refrigerator temperature.
- K06: Adequate handwash facilities supplied, accessible
Bar paper towel dispenser is not closed , paper towels are exposed. [CA] Ensure paper towel dispenser is properly locked at all times to prevent contamination.
- K34: Warewash facilities: installed/maintained; test strips
Lack of plugs/stoppers to fill up the 3 compartment warewashing sink. [CA] Plugs/stoppers shall be available to properly fill up the warewashing sink.
- K48: Plan review
REPEAT VIOLATION: Facility has not submitted plans regarding the newly installed water heaters. Previously documented on routine inspection reports: 2/1/2024, 12/23/2024. [CA] Prior to the installation of any new equipment, submittal is required to our Plan Check Department. Contact DEH Plan Check at (408)918-3400 or www.ehinfo.org to obtain plan check requirements. Plans must be submitted by 01/05/2026. Note: Plan check consultation hours are Monday- Friday: 730AM-10AM and afternoon by appointment only at address above.
- K21: Hot and cold water available
REPEAT VIOLATION: Water temperature at bar 3 composition sink measured 115F. [CA] Hot water shall be supplied at a minimum temperature of at least 120°F measured from the faucet throughout facility except at handwash sinks.