77
Latest score
100%
Pass rate
2
Inspections
2
Critical violations

Location

Latest inspection

PASSED
Mar 31, 2026ROUTINE INSPECTION137 days ago

Inspection Timeline

Mar 31, 2026Latest
PassedScore: 77/100
ROUTINE INSPECTION
77
Mar 4, 2025
PassedScore: 81/100
ROUTINE INSPECTION
81

Violations Analysis

2
Critical Violations
2 in last 3 inspections
11
Non-Critical
13
Total Violations
Across 2 inspections

Complete inspection history

2 inspections
PassLatest Mar 31, 2026
77/100

ROUTINE INSPECTION

7 reported violations
  • K40: Wiping cloths: properly used, stored

    WIping towels are observed used, reused, and stored on prep surfaces. [CA] Wiping towels shall be stored in sanitizing solution of an approved concentration when not in use (100 ppm - chlorine, 200 ppm - quaternary ammonium).

  • K06: Adequate handwash facilities supplied, accessible

    Handwash sink located in the back prep area is not easily accessible due to being partially obstructed by equipment. [CA] All handwash sinks shall be readily accessible for employees to easily wash their hands when required.

  • K07: Proper hot and cold holding temperaturesCritical

    Potentially hazardous foods measured at improper cold holding temperatures. Raw chicken wings and sausages overstacked in the food prep unit inserts were measured at 50-52F. [CA] Potentially hazardous foods when cold holding shall be held at or below 41F. [COS] Employee relocated the over stacked food items that were at improper temperatures and relocated them into the walk-in cooler.

  • K16: Compliance with shell stock tags, condition, display

    Shellstock tags are not maintained for 90 days [CA] Shellstock tags shall be maintained for 90 days and kept in chronological order correlated to the date of the date the shellstock are sold or served.

  • K21: Hot and cold water available

    Lack of hot water at the handwash sink located by the cook line. Hot water handle at the sinks faucet is in disrepair [CA] Handwash sink shall be able to provide warm water measured at 100 F.

  • K36: Equipment, utensils, linens: Proper storage and use

    Knife observed stored with it's blade in the crevice between two refrigeration units. [CA] Knife shall be stored in a manner where the food contact surface is kept clean and protected from contamination.

  • K29: Toxic substances properly identified, stored, used

    Multiple spray bottles observed in the food prep areas and are not labeled. [CA] Spray bottles used in a food facility shall be labeled to identify it's contents.

Pass Mar 4, 2025
81/100

ROUTINE INSPECTION

Routine inspection conducted in conjunction with CO0156351

6 reported violations
  • K40: Wiping cloths: properly used, stored

    Wiping towels are used, reused, and stored on food prep surfaces. [CA] Wiping towels shall be stored in sanitizing solution of an approved concentration when not in use (100 ppm - chlorine, 200 ppm - quaternary ammonium).

  • K30: Food storage: food storage containers identified

    Containers of food are stored on the floor inside the walk-in cooler. [CA] Food shall be stored a minimum of 6 inches off the floor.

  • K09: Proper cooling methods

    Cooked potatoes measured at 99F are cooling inside the walk-in cooler while fully covered with a lid. [CA] Potentially hazardous foods when cooling shall be loosely covered or uncovered to facilitate rapid cooling.

  • K07: Proper hot and cold holding temperaturesCritical

    Clam chowder in the hot holding unit is measured at 116F. [CA] Potentially hazardous foods when hot holding shall be held at or above 135F. [COS] Employee was unsure how long the food was out of temperature and voluntarily discarded the food. Minor violation: The following potentially hazardous foods inside the walk-in cooler was measured at improper cold holding temperatures: sausage, noodles, and raw shell eggs measured at 46-48F. [CA] Potentially hazardous foods when cold holding shall be held at or below 41F.

  • K29: Toxic substances properly identified, stored, used

    Spray bottle near the prep area is not labeled. [CA] Spray bottles used in a food facility shall be labeled to identify it's contents.

  • K41: Plumbing approved, installed, in good repair; proper backflow devices

    Drain line from ice machine extends into the floor sink. [CA] Provide a minimum of a 1 inch air gap between the end of the drain line and the rim of the floor sink to protect equipment from back flow contamination.

Source: Santa Clara County open data. Records are supplied as-is and may take 24–48 hours to reflect a newly published inspection.