ROUTINE INSPECTION
3 reported violations
- K41: Plumbing approved, installed, in good repair; proper backflow devices
Faucet at janitorial sink was leaking with water turned off. [CA] Repair plumbing fixture and maintain in clean and good repair.
- K22: Sewage and wastewater properly disposed
Water in handwash sink was slow to drain, while testing for warm water, sink basin filled up with water. Once water was turned off, water was able to drain out of sink. [CA] Repair/replace plumbing so that wastewater is disposed of efficiently.
- K21: Hot and cold water available
Hot water measured 118F at janitorial sink after allowing the water to run for several minutes. Temperature then dropped to 106F. [CA] Hot water shall be supplied at a minimum temperature of at least 120°F measured from the faucet throughout facility except at handwash sinks. Warm water measured 98F at handwash sink in restroom after allowing water to run. [CA] Handwashing facilities shall be equipped to provide minimum 100°F water under pressure for a minimum of 15 seconds.